I have NBR 3.01 on a USB stick. When I boot with it, I can't get either the wired or wireless NIC to work. ifconfig only shows pan0 and the loopback adapter. The wireless adapter shows active. (Blue light is on and eeePCtray shows it on).

I have created a wired and wireless NIC.

When I run sudo iwlist scanning, I get the error:

pan0: Interface does not support scanning.

Any ideas what I am missing?

Forgot to mention that the model is a 1005HA.

Here is some output from diagnostic commands recommended in another post:

eeebuntu@eeebuntu:~$ sudo lshw -C network
*-network UNCLAIMED
description: Network controller
product: AR9285 Wireless Network Adapter (PCI-Express)
vendor: Atheros Communications Inc.
physical id: 0
bus info: pci@0000:02:00.0
version: 01
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: latency=0
*-network UNCLAIMED
description: Ethernet controller
product: Attansic Technology Corp.
vendor: Attansic Technology Corp.
physical id: 0
bus info: pci@0000:01:00.0
version: c0
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress vpd bus_master cap_list
configuration: latency=0
*-network DISABLED
description: Ethernet interface
physical id: 1
logical name: pan0
serial: f6:26:7b:12:73:12
capabilities: ethernet physical
configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A link=yes multicast=yes



eeebuntu@eeebuntu:~$ cat /etc/network/interfaces
auto lo
iface lo inet loopback


eeebuntu@eeebuntu:~$ cat /etc/lsb-release
DISTRIB_ID=Ubuntu
DISTRIB_RELEASE=9.04
DISTRIB_CODENAME=jaunty
DISTRIB_DESCRIPTION="Ubuntu 9.04"

eeebuntu@eeebuntu:~$ uname -a
Linux eeebuntu 2.6.28-11-generic #42-Ubuntu SMP Fri Apr 17 01:57:59 UTC 2009 i686 GNU/Linux

eeebuntu@eeebuntu:~$ iwconfig
lo no wireless extensions.

pan0 no wireless extensions.

1005HA is newer than the kernel used in Eeebuntu 3.0. Thus, neither of the adapters, LAN or WAN, is supported. You'll need an updated kernel to properly use either. Obviously this is a problem without internet access. You'll have to download the proper deb files to USB drive from a different computer, then install them on the 1005HA.

Unless something's changed that I'm unaware of.

1005HA requires at least the 2.6.30-generic kernel.
viewtopic.php?f=7&t=3866